- 您现在的位置：买卖IC网 > Sheet目录470 > MAX11008EVC16 (Maxim Integrated)EVAL KIT MAX11008
Dual RF LDMOS Bias Controller with
Nonvolatile Memory
complete the ADC powers down, BUSY is pulled low,
and the results for all of the selected channels are
available in the FIFO.
The duration of the BUSY pulse is additive, depending
on the channel conversion sequence selected. The
BUSY pulse is set typically for 72μs by temperature
conversions; 52μs by PGAOUT conversions, and 7μs
by ADCIN conversions.
Clock Mode 01
In clock mode 01, power-up, acquisition, conversion,
and power-down are all initiated through a single pulse
on CNVST and performed automatically using the inter-
nal oscillator. Initiate a scan by writing to the ADC con-
version register and setting CNVST low for at least
20ns. The ADC sets the BUSY output high, powers up,
and scans all requested channels storing the results in
the FIFO if the ADCMON bit has been set. After the
scan is complete, the ADC powers down, BUSY is
pulled low, and the results for all of the selected chan-
nels are available in the FIFO. The BUSY pulse behav-
ior is identical to that of clock mode 00.
Externally Timed
Acquisitions and Conversions
Clock Mode 10
Clock mode 10 is reserved. Do not use this clock
mode.
Clock Mode 11
In clock mode 11, set the FBGON bit. Conversions are
initiated one at a time through CNVST and performed
using the internal oscillator. In this mode, the acquisition
time is controlled by the time CNVST is low. CNVST is
resynchronized by the internal oscillator, resulting in a
one-clock cycle (typically 320ns) uncertainty in the exact
sampling instant. Different timing parameters apply
depending if the conversion is temperature, from ADCIN,
or from PGAOUT (as specified in the Clock Mode 00
section). Figure 15 shows a conversion time example.
Both internal and external temperature conversions are
internally timed. Pull CNVST low for a minimum of 20ns
(t CNV11 ) to trigger a temperature conversion. The BUSY
output goes high and the temperature conversion result
is available in the FIFO (if the ADCMON bit is set) 72μs
(typ) after BUSY goes low again.
INTERNAL TEMPERATURE READING, PGA1 OUTPUT, AND ADCIN1 CONVERSION TIMING IN CLOCK MODE 11
CNVST
BUSY
t CNV = 20ns (typ)
t ACQ = 30 μ s (typ)
t ACQ = 1.5 μ s (typ)
INTERNAL
OPERATIONS
TEMPERATURE
CONVERSION
70 μ s (typ)
IDLE MODE,
REF AND
TEMP
SENSOR
POWERED
PGA 1
ACQUISITION
PGA 1
CONVERSION
22 μ s (typ)
IDLE MODE,
REF AND
TEMP
SENSOR
POWERED
END OF
SCAN
WRITE TO ADC
CONVERT REGISTER TO
SET UP ADC SCAN
FBGON = 1,
ADCMON = 1
TEMPERATURE
CONVERSION RESULT
AVAILABLE IN FIFO
PGA 1 OUTPUT
CONVERSION
RESULT AVAILABLE
IN FIFO
ADCIN 1
CONVERSION
RESULT AVAILABLE
IN FIFO
Figure 15. ADC Clock Mode 11 Example
26
______________________________________________________________________________________
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MAX11014BGTM+T
IC RF MESFET AMP 48-TQFN-EP
MAX12000ETB+T
IC AMP GPS FRONT 1575MHZ 10TDFN
MAX12005ETM+T
IC SATELLITE IF SWITCH 48-TQFN
MAX1385BUTM+
IC RF LDMOS BIAS CNTRLR 48-TQFN
MAX1470EUI+T
IC RECEIVER 315MHZ 28-TSSOP
MAX1470EVKIT-315
EVAL KIT FOR MAX1470 315MHZ
MAX1471EVKIT-315
EVAL KIT FOR MAX1471 315MHZ
MAX1472EVKIT-433#
EVAL KIT MAX1472
相关代理商/技术参数
MAX11008EVKIT+
功能描述:放大器 IC 开发工具 MAX11008 Eval Kit RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V
MAX1100CWG
制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述:
MAX1101
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Single-Chip, 8-Bit CCD Digitizer with Clamp and 6-Bit PGA
MAX11014
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Automatic RF MESFET Amplifier Drain-Current Controllers
MAX11014_08
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Automatic RF MESFET Amplifier Drain-Current Controllers
MAX11014BGTM
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:Automatic RF MESFET Amplifier Drain-Current Controllers
MAX11014BGTM+
功能描述:特殊用途放大器 Auto RF MESFET Amp Drain-Current Cntrlr RoHS:否 制造商:Texas Instruments 通道数量:Single 共模抑制比（最小值）: 输入补偿电压: 工作电源电压:3 V to 5.5 V 电源电流:5 mA 最大功率耗散: 最大工作温度:+ 70 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-20 封装:Reel
MAX11014BGTM+T
功能描述:射频放大器 Auto RF MESFET Amp Drain-Current Cntrlr RoHS:否 制造商:Skyworks Solutions, Inc. 类型:Low Noise Amplifier 工作频率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 输出截获点:37.5 dBm 功率增益类型:32 dB 噪声系数:0.85 dB 工作电源电压:5 V 电源电流:125 mA 测试频率:2.6 GHz 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-16 封装:Reel